Keep flame down about 1/2' or so to start and find what distance works for your heat source.

Put powder in spoon, spread it out a little bit and make a couple channels through the middle, evenly sprinkle soda on topДЄdd distilled water, about 1ml for half g, add drop by drop around edges of powder and a few in middle and mix until its all wet and a white foamy mass with just a little extra water around it.ДЄdd heat evenly around the bottom of spoon, try to not let any one spot get too hot. Weigh out soda to be 30% of your gear (so 1g would get. Bend the spoon so that the bowl is flat on your table.Д¬rush gear like you would for bumps, finer the better You can do this just holding the spoon or can find somewhere to secure the spoon on an edge of something, like a table or bookshelf and put duct tape or something heavy on the end so that spoon aint going nowhere. Heat source: lighter, torch, candle, gas stoveД¬ooling: Ice Cube, wet towel, cup filled with cold water Large metal spoon or soup ladle (anything metal with rounded bottom)Дistilled water (or any clean filtered water, tap water last resort)ДЇresh Baking Soda (Must be sodium bicarbonate)Д¬ollection Tool: Penny (pre-1982 are 95% copper, post 1982 are 95% zinc, crack loves copper) or knife or nail or anything metal

You can stop cooking and collect oil at any point after the foamy reaction, but the earlier you pull it the more impurities it will have. You want to keep cooking until water and oil are mostly clean of bubbles, solids and any milky/cloudy stuff for the cleanest, tastiest rocks. It needed a drop or 2 more water at start and a little more once it went oil, the oil and water were still slightly cloudy. This cook was cut short just before oil was fully done clearing out the crap. Video: this video is not a perfect cook, but gives a good idea of the process and the result was certainly enjoyable, perhaps one day it will get updated with a more refined method. This guide is just looking to put the basics out there to help others. It is by no means the only way, best way, or most efficient way and I encourage other more experienced people to offer suggestions, improvements, alternatives or corrections to make this thread as informative as possible. This guide lays out simply a pretty easy process for using the tried and true spoon method.

How to re rock crack in a spoon